NEW Models and Steam Fittings

7" flywheel / Casted of Old Stuart Casting

7" flywheel / Casted of Old Stuart Casting

These came out of a workshop i just cleard,

all good quality castings, just need machining!

More...

4" Flywheel / Casted of old Stuart Casting

4" Flywheel / Casted of old Stuart Casting

this casting is good quality

needs machining to suit your needs

"cast iron"
More...

Displacement lubricator for small steam engines

Displacement lubricator for small steam engines up to 1inch cylinder bore.

The lubricator is threaded 1/4" x 40.

This lubricator should be attached to the steam chest or fitted to the steam line close to the engine by a tee piece.

Operating the needle valve lets steam pass into the lubricator. Steam condenses in the lubricator and sinks to the bottom. Oil is displaced by the water and passes into the steam line lubricating the engine.

More...

4x Oil Cups "5BA" for Stuart Models

4x Oil Cups "5BA"

Live Steam Compatible with Stuart Models

Please take a look at the larger picture

More...

R/C Steam Regulator Valve Compatible with Stuart

The 21st-Century Steam Company series of radio controlled steam regulator valves are designed to provide a smooth and progressive control of the steam supply, from closed to fully open. Thus providing effective throttle control for model steam engines.

Obviously the steam regulator valve can be used manually with any make of model steam engine, to give you total control of your engine.

The regulator valve is simple to fit, and should be fitted directly into the steam supply line, between the engine lubricator and the engine inlet manifold.(Please see diagram) The rotational range of operation is approximately 90° and may be operated using a, single, standard servo. These valves like all our products are professionally made using only the highest quality materials to give many years of service.

All threads on the inlet & outlet are 1/4" x 40" tpi- with nipples for 5/32" pipe.

"£1.00 coin not included for size reference only"

More...

Stuart Turner compatible Working Governor

Stuart Turner compatible Working Governor

Governor system will fit s.50 etc

this kit comes complete with everything you will need and can be fit in a few minutes

"No Machining required"

Your engine must be made to s50 blueprints

the steam chest cover is tapped standard 3/16 x 32

Steam Engine Boiler Feed Hand Pump

Steam Engine Boiler Feed Hand Pump

The Pump is 3 1/4" long from the end of the bottom union to the handle link

The Base is 5/8" wide x 1 5/8" long,

The Handle is 2 1/2" long

All Threads on the water inlet and outlet are 1/4" x 40tpi with nipples for 5/32 pipe

This is the first series and the smallest Boiler feed hand pump we make a 3/8 ram, fitted with o ring seal

as with all our products this is professionally made, They are fabricated from highly polished brass and silver soldered

Drain Cocks / Compatible with Stuart 2

Drain Cocks / Compatible with Stuart 2

Compatible with stuart 2,

Drain cocks tapped 5/32 x 40

2 x drain cocks
More...